How do you turn on the Atwood Hydro flame furnace?
Ava Wright
Published Feb 07, 2026
How do you turn on the Atwood Hydro flame furnace?
How to Light an Atwood Hydro-Flame Furnace
- Charge your RV’s battery up and turn the Atwood Hydro-Flame furnace’s gas valve on to the “pilot” position.
- Light a match while pushing and holding the gas valve.
- Allow the gas flame to burn for a moment before switching the gas valve over to the “on” position.
Why does my Atwood water heater not light up?
Atwood RV Water Heater Won’t Light When this happens to the GH6-6E Atwood water heater then the source of the problem could be the regulator or the thermostat or both. The solution t this problem, if these are the source, is to replace them.
How to test the Atwood water heater thermostat?
How to Test Atwood Water Heater Thermostat. The best way to test this part on your water heater is by using a continuity tester. When the water is cold there should be continuity between the contacts. When the water is hot there should be no continuity.
What kind of circuit board do I need for my Atwood water heater?
The quickest way to test a circuit board for your water heater is to use the circuit board from your Hydroflame furnace if you have one. The 8500 or 8900 models are the most compatible with your Atwood heater and should plug in easily. There will be the same 20-second delay that happens on your furnace when you power up the water heater.
Atwood RV Water Heater Won’t Light When this happens to the GH6-6E Atwood water heater then the source of the problem could be the regulator or the thermostat or both. The solution t this problem, if these are the source, is to replace them.
What’s the flame on an Atwood fifth wheel?
Atwood Hydro Flame 8940 in a fifth wheel. Turns on OK, fan starts, gas ignition occurs. Stays lite for about 5 seconds and then goes out, lites again in about 10 seconds. Continues this cycle until turn the stat down. Does not provide enough heat to maintain temp.
What happens if my Atwood flame furnace stops working?
That means if you fail to get the RV furnace back to work, it would get very cold later tonight. In the case you don’t want to get sick due to low temperatures, this troubleshooting guide is for you. Everything you need to know Atwood hydro flame furnace including working principles, problem symptoms and more are presented downs below.
How to Test Atwood Water Heater Thermostat. The best way to test this part on your water heater is by using a continuity tester. When the water is cold there should be continuity between the contacts. When the water is hot there should be no continuity.
